Sale!
41Z39X1oNyL.jpg4148wYJMWKL.jpg

A4988 Stepper Motor Driver For RepRap Prusa Mendel

$7.99 $3.99

100 in stock

Product Description

Product Description This product is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection; we therefore recommend careful reading of the A4988 datasheet (380k pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2 A output current per coil (see the Power Dissipation Considerations section below for more information). The equivalent to A4983-board but offers over current protection. If the boards get too hot, they will interrupt the current until it cools a bit. If the current is too high for the heat sinking, the motors will pulse as the current is interrupted and restored. Feature: Simple step and direction control interface Five different step resolutions: full-step, half-step, quarter-step, eighth-step, and sixteenth-step Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay) Over-temperature thermal shutdown, under-voltage lockout, and crossover-current protection Short-to-ground and shorted-load protection

Reviews

There are no reviews yet.

Be the first to review “A4988 Stepper Motor Driver For RepRap Prusa Mendel”

Your email address will not be published. Required fields are marked *